Mettler Toledo M300 FLOW Spezifikationen PDF herunterladen (Seite 17)

Transmitter M300 FLOW 17

Printed in Switzerland 52 121 319

4.1.4 Installation procedure – 1/2DIN models

For Wall Mount:

– Remove rear cover from front housing.

– Start by unscrewing the four screws located on the face of the transmitter, in each corner.

This allows the front cover to swing away from the rear housing.

– Remove the hinge-pin by squeezing the pin from each end.

This allows the front housing to be removed from the rear housing

– Drill out wall-mount breakthroughs in the rear housing.

– Mount rear housing to wall using appropriate mounting hardware for wall surface. Be sure

it is level and securely fastened and the installation adheres to any and all clearance

dimensions required for transmitter service and maintenance.

– Insert two black protective covers (supplied with the M300 transmitter) over the ﬁxing

hardware and into the space on the inside back cover, as shown in the drawing below.

This is necessary to maintain unit integrity.

– Replace the front housing to the rear housing. The unit is ready to be wired.

For Pipe Mount:

– Use only manufacturer-supplied components for pipe-mounting the M300 transmitter and

install per the supplied instructions. See section 15 for ordering information.

5.90

[150]

5.90

[150]

0.256

[6.5]

3.30

[84]

1.65

[42]

4.56

[116]

1.13

[28.7]

1.15

[29.2]

3.54

[90]

2.95

[75]

0.236

[6]

1.38

[35]

3.15

[80]

5.36

[136]

5.36

[136]

CABLE GLAND OR

CONDUIT BREAKTHROUGHS

ø1/2" (ø 21.5mm)

PIPE MOUNTING

BREAKTHROUGHS

(4 PLACES)

WALL MOUNTING

BREAKTHROUGHS

(2 PLACES)

CABLE GLANDS

(3 PLACES)

ESC

EnterInfoCalMenu

METTLER TOLEDO

M300

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

Mettler Toledo M300 FLOW Spezifikationen Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messen, Testen & Steuern Mettler Toledo M300 FLOW