Mettler Toledo PS6L Spezifikationen PDF herunterladen (Seite 33)

Chapter 3: Configuring the Setup Parameters

Configuring Setup Parameters

Zero Cursor Program

Block

The Zero Cursor program block lets you enable or disable the center of zero

indicator on the PS. (Metrology PCB jumper must be removed.)

To configure the program block:

1. Press UNITS to display the 0 CurS prompt, then press ZERO.

2. Press ZERO to display the desired approval setting, enable or disable.

3. Press UNITS to accept the displayed option. The PS continues to the

Power-up Unit program block.

Power-up Unit

Program Block

The Power up Unit program block lets you select which units will be active on

the PS upon startup. This program block will effect the build options that are

seen in the Build program block.

To configure the program block:

1. Press UNITS to display the unitS prompt, then press ZERO.

2. Press ZERO to display the desired approval setting, pounds or metric.

3. Press UNITS to accept the displayed option. The PS continues to the

Build / Alternate Units program block.

Build Program Block

The build program block lets you chose a capacity and increment size setting

for the product based on the model you have purchased and the power-up units

selection. (Metrology PCB jumper must be removed.)

To configure the program block:

1. Press UNITS to display the buiLd prompt, then press ZERO.

2. Press ZERO to display the desired approval setting. Option may vary as

follows:

PS60

Power-up units = Pounds Power-up units = Metric

150-02 150 x 0.02 lb. 60-01 60 x 0.01 kg

150-05 150 x 0.05 lb. * 60-02 60 x 0.02 kg

60-ni 200-ni 150 x 0.05 lb., 150-

200 x 0.1 lb.*

0-30 x 0.01 kg, 30-60 x 0.02 kg

70-ni 0-50 x 0.01 kg, 50-70 x 0.05 kg

(08/04) 3-3

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 71 72

Keine Kommentare

Mettler Toledo PS6L Spezifikationen Seite 33